Aprilia Tuono V4 R - The Real Superbike Streetfighter | First Ride

Aprilia redefined the Streetfighter category with the introduction of the V-twin Tuono 1000 R back in 2002 — a bike that was such fun to ride it earned both critical acclaim and showroom success, based as it was on the Italian manufacturer’s RSV 1000 R Superbike. But with the launch of the RSV4 in 2009 with its 65-degree V-four engine designed by legendary Ferrari progettista Claudio Lombardi, Aprilia has built on that platform, just as it did a decade ago with the RSV 1000 R V-twin, and has now produced a real-world ride that sets new standards for the naked bike category. Besides the base model (selling for €13,590, about $19,000), for an extra €2000 ($2800) you can get the APRC version complete with the same eight-stage traction control, three-stage anti-wheelie control, AQS powershifter and ALC launch control as on the RSV4 equivalent.

While the 78 x 52.3mm basic architecture of the 999.6cc V-four motor remains unchanged, there have been several detail changes aimed at altering its character and power delivery. Heavier flywheels on the crank help deliver a smoother pickup down low, and the variable intake system of the RSV4 has been omitted on the 48mm Dell’Orto throttle bodies. The stock velocity stacks have also been increased by 20mm in terms of overall length, in order to fatten low-rpm and midrange performance. The gear-driven single counterbalancer mounted low in front of the front cylinder block has also been revised, and while the pairs of 32mm titanium inlet and 28mm nimonic steel exhaust valves sitting at an ultra-flat 22-degree included angle are unchanged, the valve timing has been altered for more torque. The six-speed gearbox retains its slipper clutch, but the bottom three ratios have been shortened to improve acceleration, while the new 4-into-2-into-1 stainless steel exhaust that’s subtly different from the RSV4’s (also nearly five pounds lighter, as is the combined weight of the Tuono’s cast aluminum wheels) carries a single oxygen sensor and three-way catalyzer, as well as a reed valve which allows air during cold starts to help counter start-up pollution issues. In addition, as on the RSV4 there’s an ECU-controlled powervalve fitted to further optimize bottom-end performance, as well as to cut down on noise in urban situations. The bottom line is that the new Tuono is already Euro 4-certified, yet the revised motor still delivers a hefty claimed 167.3 horsepower at 11,500 rpm and 82.2 ft-lb of torque at 9500 rpm. The new Tuono makes just 13 horsepower less than the RSV4, but with a broader spread of torque, and the Tuono’s rev limiter is set at 12,300 rpm, 1000 rpm lower than the RSV4.

Fronting up at Aprilia’s Noale headquarters on a sunny spring morning, I found the keys of a yellow-and-black-liveried APRC version of the Tuono V4 R awaiting me (also available in all-black and all-grey paint schemes). Climbing aboard, I found a great riding position via the flat one-piece taper-section handlebar mounted to the upper triple clamp. While inevitably a bit sporty, but with more room than on the RSV4 thanks to the lower footrests, the Tuono’s stance doesn’t put too much weight on your arms and shoulders, and in a full day ride I never got tired. In fact, Aprilia tester Carlo Zuin led me on a full 186-mile day that showed to best advantage the new Tuono’s astonishing all-round abiltities, as he led me first south from Noale to the Adria race circuit where I put in 40 laps in a track-day session. Then we headed over to the Colli Euganei volcanic hills south of Padova for a satisfying squirt through their twists and turns, interspersed with a bit of street work while sightseeing in some of the scenic towns along the way, before taking the autostrada back to Noale.

This evolved version of the reigning World Superbike champion motor is installed 5mm lower in a visually identical but subtly re-jigged aluminum twin-spar frame in order to lower the center of mass for easier turn-in and to counter the risk of wheelies, according to Aprilia R&D boss Mariano Fioravanzo. You can’t alter the location of the engine in the chassis as you can on the RSV4 Factory, he reveals — but the whole bike is set 10mm closer to the ground, resulting in a 10mm-lower 32.9-inch seat height versus the RSV4. The footpegs are 15mm lower than the RSV4, with the fully adjustable 43mm Sachs fork mounted in a steering head that’s 10mm further forward, resulting in a 25mm-longer 56.9-inch wheelbase. This in turn sees the Tuono’s claimed 403-pound dry weight evenly split 50/50 front to rear, against the 52/48 percent distribution of the RSV4’s 395 pounds. The head angle and trail are set at 25 degrees/107.5mm on the Tuono, against 25.4 degrees/105mm for the Superbike — a subtly sharper difference on the Tuono that improves the handling according to Fioravanzo.